Licensed Professional Engineers |
Search/

Request a free quote

Selected Projects

Electrical Service Design and Load Calculation for Two New Extruder Skids at a Plastics Plant, Houston (2018 to 2019)

We typically respond within one business day.

Project at a glanceDE-PRJ-10843

Location
Houston, TX
Service
Electrical design, load analysis
Client
Confidential

Electrical Service Design and Load Calculation for Two New Extruder Skids at a Plastics Plant, Houston (2018 to 2019)

A plastics manufacturer in Houston added two extruder and chipper skids and needed a new electrical service to run them. We prepared the permit drawings in 2018 and issued the construction set, with its load calculation, in April 2019.

The load

The calculation added up the largest load each major piece of equipment can draw at the same time: 500 kVA for one extruder skid, 339 kVA for the other, and 500 kVA on the existing main distribution panel, for a total design load of 1,339 kVA, or 1,610 A. With equipment and protection rated for continuous full load, that left 323 kVA, or 390 A, of spare capacity.

The service

The utility supplies a new pad-mounted transformer at 480Y/277 V. From it, five sets of 500 kcmil conductors run direct buried, 5 feet deep, to an outdoor 600 V, 2,000 A disconnect in a NEMA® 3R enclosure, with a 2,000 A main breaker and ground fault protection. A 1,600 A load-break switch fused at 1,200 A feeds an indoor 1,400 A switchboard rated 35 kA. The switchboard feeds each skid through 400 A, 125 A and 400 A breakers, and a 45 kVA transformer steps 480 V down to 240 V for smaller loads on the second skid. The existing 600 A main panel and the rest of the plant stay as they were.

Related services

See our electrical design services for packages like this one, and load analysis for the capacity side.

Get your project started

We typically respond within one business day.

Request a free quoteor call (866) 621-6920